Projects / Serving board plans / 9×16 inches
9×16 serving board
A 9×16-inch serving board from a single 1×10 hardwood offcut, with eased edges and an oiled finish.
Beginner1 hour1 part1× board
Have scraps? Check this project against your wood
Cutting diagram
Bright pieces are your parts; the dimmed wood is left over. Every cut allows ⅛″ for the saw blade.
Cut list
| Part | Qty | Width × length | Cut from | |
|---|---|---|---|---|
| A | Board | 1 | 9¼″ × 16″235 × 406 mm | 1× board |
How to build it
- Pick a hardwood 1×10 with no cracks or knots near the ends. Maple, cherry and walnut are ideal.
- Cut it to 16″ and mark a gentle radius on each corner by tracing a mug.
- Cut the corners, then sand the faces and edges from 80 to 220 grit, rounding the edges so they feel soft in the hand.
- Wipe with a damp cloth to raise the grain, let it dry, and sand once more at 220.
- Flood the board with mineral oil, wait 20 minutes, wipe off the excess, and repeat the next day.