Projects / Monitor riser plans / 30″ wide, 11¼″ deep
30″ monitor riser, 11¼″ deep
A 30-inch riser, 11¼″ deep, that lifts a monitor 4″ with room for a keyboard underneath. Wide enough for two small screens.
Beginner1 hour3 parts1× board
Have scraps? Check this project against your wood
Cutting diagram
Bright pieces are your parts; the dimmed wood is left over. Every cut allows ⅛″ for the saw blade.
Cut list
| Part | Qty | Width × length | Cut from | |
|---|---|---|---|---|
| A | Top | 1 | 11¼″ × 30″286 × 762 mm | 1× board or ¾″ plywood |
| B | Leg | 2 | 11¼″ × 4″286 × 102 mm | 1× board or ¾″ plywood |
How to build it
- Cut the top at 30″ and two legs at 4″ from 1×12 stock.
- Drill two pocket holes in the top edge of each leg, or plan to screw down through the top.
- Attach the legs 1″ in from each end of the top.
- Round over the front edge so it's comfortable against your wrists.
- Finish with a hard-wearing wipe-on poly.