Projects / Picture frame plans / 8×10 photo
8×10 picture frame
A mitered frame for an 8×10 photo, cut from 1×2 stock, with a rabbet for the glass.
Intermediate2 hours4 parts1× board
Have scraps? Check this project against your wood
Cutting diagram
Bright pieces are your parts; the dimmed wood is left over. Every cut allows ⅛″ for the saw blade.
Cut list
| Part | Qty | Width × length | Cut from | |
|---|---|---|---|---|
| A | Top and bottom rail | 2 | 1½″ × 10½″38 × 267 mm | 1× board |
| B | Side rail | 2 | 1½″ × 12½″38 × 318 mm | 1× board |
How to build it
- Rout or saw a ⅜″ × ⅜″ rabbet along one edge of a 1×2 board before cutting it into pieces. It's much safer on a long piece.
- Miter both ends of each piece at 45° so the long edges measure 10½″ and 12½″. The glass pocket then measures 8¼″ × 10¼″, which gives the 8×10 glass a little room.
- Dry-fit the corners and adjust until the joints close with no gaps.
- Glue the miters and hold them with a band clamp or masking tape until dry.
- Finish the frame, then fit the glass, photo and backer, and hold them in with turn buttons.